盘式（圆盘）真空过滤机日常如何保养维护？？？

1、操作者不应离开岗位，并注意控制盘和模拟屏上的讯号，如发现异常现象应及时采取措施。

1. Operators shall not leave working post and shall pay attention to signal shown on control panel and imitation screen, taking measures if any abnormal phenomenon is found.

2、经常检查各部件的紧固情况，不允许有松动现象。

2. Check fastening condition of each component frequently, and no loosening phenomenon is allowed.

3、经常检查真空管路有无漏气现象，真空表指示是否正常。

3. Check whether vacuum pipe is air-leaked and whether indication of vacuum gauge is normal.

4、经常检查各电机、各轴承温度是否正常。

4. Check whether temperature of each motor and each bearing is normal.

5、经常检查滤盘运转是否平稳，滤布是否完好无损，刮刀工作是否正常。

5. Frequently check whether filter disc is running stably, whether filter cloth is intact, and whether scraper works normally.

6、检查主轴运转是否平稳，开式齿轮付接触面是否均匀，并保持齿面有油脂。

6. Frequently check whether spindle is running stably, whether contact surface of open gear is uniform. And grease shall be kept on surface of gear teeth.

7、观察槽内液面，判断搅拌效果，并经常检查盘根处密封状态，并保证水封供水正常。如果盘根泄漏严重应及时压紧盘根。

7. Observe liquid level inside trough to judge stirring result. And check sealing status at disc-root frequently and ensure that water-supply of water-sealing is normal. Disc-root shall be compacted tightly if there is serious leakage.

8、经常检查液位是否处于预定位置，必要时应加以调整。

8. Check whether liquid level is on preset location, and adjust it if necessary.

9、观察入料、排料是否正常，滤饼的厚度和水份有无异常现象。

9. Observe whether feeding and discharging are normal and whether there is abnormal phenomenon about thickness and moisture of filter cake.

10、分配盘上的四个弹簧必须均匀压紧。两个调节空气进入阀开口适当。

10. Four springs on distribution disc must be compacted evenly. Opening degree of two air-regulating inlet-valves shall be proper.

11、经常检查各润滑点的润滑情况，并及时向干油桶补充干油。个别部位（搅拌轴承座、减速器）要采用人工加油。各润滑及要求见表。

11. Check lubrication conditions of each lubrication point frequently and complement grease into grease barrel in time. Manual oiling shall be adopted for some exceptional parts (stirring bearing seat, reducer). Each lubrication and requirements are shown as follows.

无锡迈勒环保科技有限公司专业生产盘式（圆盘）真空过滤机、带式真空过滤机、陶瓷过滤机等真空固液分离设备。咨询电话：15152237223（邱先生）